Advertisement
TS-770-GV and TS-1070-GV
7 in. and 10.1 in. Tabletop Touch Screens, Government Version
Connect the Touch Screen
Route all necessary cables to the touch screen, and then make
connections to the bottom of the touch screen.
Observe the following when connecting the touch screen:
Power and data connection is provided to the touch screen by a single
l
Ethernet cable. A Crestron PoE (Power over Ethernet) power supply,
such as the PWE-4803RU, or a PoE-capable network switch is
recommended (both not included).
The USB port is used to connect compatible Crestron LED accessories
l
to the touch screen.
NOTE:
The TS-770-GV may use either PoE or PoE+ to supply power
to compatible LED accessories over USB; the TS-1070-GV must use
only PoE+ to supply power to LED accessories over USB.
Apply power after all connections have been made.
l
Install the Cable Grommet
The touch screen ships with two cable grommets that can used depending
on the planned cable route to the touch screen:
Use the open grommet if cables will be routed out from the rear of the
l
touch screen. A cable compartment cover is also provided for this
installation.
Use the closed grommet if cables will be routed from underneath the
l
touch screen.
To install the cable grommet:
1. If using the open grommet, push the cables into the openings in the
grommet.
2. Push the grommet into its slot on the bottom of the touch screen so
that the two tabs on either side of the grommet engage the slots in
the touch screen.
3. If using the open grommet, slide the cable compartment cover into its
slot on the bottom of the touch screen so that the front tab engages
the latch.
Quick Start
2
Advertisement
