Table of Contents
Advertisement
ABB i-bus
®
KNX
Commissioning
The following message appears if Multicast or Unicast is selected:
The device name, IP address and
tunneling servers are set in the
Properties window of ETS.
The following note also appears with the selection Unicast:
Attention! This setting switches off routing for the device. The IP telegrams will now be sent as
unicast to up to nine target addresses.
Unicast configuration is performed with the ABB i-bus
See the description Unicast communication, chapter 4.1.2,
You can download the i-bus
No ETS or installation of Falcon is required for the i-bus
System requirements: system with Windows 7 operating system (service pack 3) or later and .NET
Framework version 4.7.2 or later.
The integrated Falcon 5.0 supports only USB and IP interfaces (no RS232).
Note
A description of the functions is provided in the i-bus
Important
Unicast communication cannot be used when KNX Secure mode is activated.
If KNX Secure mode is activated and the parameter Type of IP communication is set to Unicast,
multicast communication will be activated anyway.
A corresponding message will be displayed when the unicast addresses are parameterized via the
i-bus
®
Tool free of charge from our homepage (www.abb.com/knx).
®
Tool.
®
Tool.
KNX telegrams in the
Tool.
®
®
Tool online help.
IPR/S 3.5.1 | 2CDC502099D0211 Rev. A 27
network.
Advertisement
Table of Contents
