Emerson FB1100 Termination Board Field Replacement Manual page 3

Hide thumbs Also See for FB1100:

FB1100/FB1200 Flow Computer Termination Board Field Replacement Guide

Removing/Replacing Termination Boards

CAUTION

MAY CAUSE INJURY TO PERSONNEL OR DAMAGE EQUIPMENT

Because I/O, ground, and other wires enter the flow computer through conduit fittings

and then connect to the termination board, a qualified technician must disconnect all

wiring coming into the flow computer and pull it out through the conduit fittings in

order to replace the termination board.

You must then install the new termination board and completely rewire the unit.

If not already done, be sure to label all wires before disconnecting so you can identify

them later during the rewiring process.

The FB1100 Flow Computer includes a single type of termination board that uses 6-

connector pluggable terminal blocks.

D301820X012

March 2018

Fb1200