Emerson FB1100 Termination Board Field Replacement Manual page 16

FB1100/FB1200 Flow Computer Termination Board Field Replacement Guide
D301820X012
March 2018
7. If battery-powered, disconnect the internal battery.
8. For the terminal block you want to replace, make sure you note which wire goes to
9. Place your fingers on each of the short sides of the terminal block and gently rock it
10. Use a flat head screwdriver to loosen the screw for each wire coming into the old
11. Repeat Steps 8 through 10 for each terminal block you want to replace.
14
which terminal. If they aren't labeled, you should label them, or take a digital
photo so you know which wire goes to which connector of the terminal block.
back and forth so it pops out of the termination board.
terminal block. Slide the same wire into the identical position on the new
(replacement) terminal block, and tighten the screw to hold it in place. Repeat for
each wire.