FB1100/FB1200 Flow Computer Termination Board Field Replacement Guide
D301820X012
March 2018
1. Remove the rear end cap by first removing the retaining clamp on the end cap (if
2. Grasp the end cap.
3. Unscrew the end cap turning it counter-clockwise until the cover comes off. Set it
12
present) using a 3 mm hexagonal wrench.
Components of Retaining Clamp Assembly (front clamp shown) Rear End Cap
1
Screw
2
Retaining Clamp
3
Washer
Rear End Cap
aside in a safe location.
Note
If you need more leverage place a long screwdriver or other appropriate tool across
the two notches in the cover to act as a pry bar.