Notes On Attaching A Commercially Available Fixing Jig; Basic Operation; Start; Changeover Switch - Nitto Kohki delvo DLV30A Series Instruction Manual

Notes on attaching a commercially available fixing jig

CAUTION
 Do not block the hole on the frame handle, as doing so could cause a failure due to heating.


6 Basic Operation

Start

WARNING
 Properly connect the power plug.

 Always make sure the tool is grounded.

No grounding the tool could cause failure or electric shock at the time of electrical leakage.
If you are not sure about the grounding of the outlet, request an electrical contractor to check if it is grounded.
When an extension cord is used, use a 3-core cord that includes a ground wire.
1
Insert the power plug into an outlet (230 V AC)

Changeover switch

CAUTION
 Do not operate the changeover switch while the tool is rotating. Doing so could cause a failure.

 When the tool is not used, set the switch to neutral position.

 Do not apply a shock (such as dropping) or excessive load to the changeover switch. Doing so could cause a

failure.
By sliding the changeover switch, you can change the rotation direction of the electric screwdriver.
" - " means neutral. The electric screwdriver does not rotate.
Fixing position of fixing jig
Rotates
counterclockwise
Rotates clockwise
Hole
EN
9