Table of Contents
Advertisement
5.4.9 Extraction system
A dust collection device should be used by the
customer
，
t he dust extraction equipment must
be switched on before commencing machining.
The outer diameter of the dust port is 4" (100mm)
(Fig.18)
Fig. 18
Requirements for the dust collector:
1. Required air flow: 470 CFM (800 m³/h).
2. Ensure pressure drop of each dust collector
outlet carrying air current speed: 1100Pa
3. Dry chips: 3937 FPM (20 m/s).
4. Wet chips: 5511 FPM (28 m/s). (water content
is equal to 18%)
5.
5.4.10 Motor cover installation
Install the motor cover by inserting the door pins
into the hinge sockets on the cabinet as shown in
Fig. 19.
Fig. 19
5.4.11 Miter gauge installation
This machine is equipped with a miter gauge. This
miter gauge is mainly used for guiding workpiece
while cross cutting and miter cutting.
Slide the miter gauge into the T-slot of the table
saw, adjust the set screw on the miter bar to
eliminate lateral play for smooth sliding action in
the T-slot.
5.4.12 Electrical installation
Wiring should only be done by professional
electricians.
Always make sure the machine is properly
grounded. All exposed conductive parts should
be connected to the protective ground circuit.
An over-voltage protection device should be
provided by end user.
The circuit breaker shall be installed to supply
electric power to this machine, in order to
protect people against electrical shock due to
incidental contact.
Check if that the voltage and frequency required by
the machine, which is shown on the machine's
name plate, correspond to the electric power
supply voltage and frequency.
A plug is provided with the machine, select a
adequate adaptor to connect.
Checking:
After finishing wiring in place, at minimum, check
the following items:
1. Check the direction of motor and change the
wiring if necessary.
2. Check the components for defects, such as
damaged cable or plug.
3. Check the function of the "OFF" button.
13
Advertisement
Table of Contents
