HARVEY C300-30 Operating Instructions Manual page 14

fence and the blade, at the rear of the blade, to
reduce the risk of workpiece binding or burning as
it is fed through the cut.
Fig. 11
4. Adjust the parallelism and perpendicularity of
the fence (Fig.12)
If the fence or blade is not parallel to the T-slot, or
the fence is not perpendicular to the table, you can
adjust as following content:
a. Align the the parallelism between the blade
and T-slot.
Before aligning perpendicularity or parallelism of
the fence, you must align the parallelism between
the blade and T-slot, refer to chapter 6.2 Aligning
the Table T-slot Parallel with the Blade.
b. Align the the parallelism between the fence
and T-slot or blade.
By adjusting the set screw (A), you can adjust the
parallelism between fence and blade, also you can
adjust the locking strength. By adjusting the bolt
marked in a circle as shown in Fig. 12, you can
adjust the the perpendicularity between the fence
and table. By adjusting the set screw (B), you can
adjust the sliding smoothness of the fence.
A
Fig. 12
By adjusting the support screw (not shown) at
the underneath of the fence, you can raise or
lower the fence to ensure that the underneath
of the fence is parallel to the table.
L
1
L
2
B
Lock Handle
A
5.4.5. Post the tape scale and calibrate
the pointer window (Fig.13)
Post the Tape Scale
Slide the fence against the saw blade, and lock it in
place; Place the front rail tape scale on the fence
tube, make sure it is parallel with the tube, and the
"0" end is directly under the red line on the pointer
window, lightly mark the "0" location on the tube
with a pencil, then remove the fence; peel the tape
and carefully align the "0" mark on the scale with
the pencil mark you made.
Calibrate the Pointer Window
Slide the fence against the blade, check that if the
"0" mark is directly under the red line on the pointer
window (B), if any deviation occurs, loosen the
knob (D), micro-adjust the pointer window (B), so
that the red line on the window is over the "0" mark
on the tape, then secure the knob (D).
Place the fence as a lower fence. Slide the fence
against the blade, check that if the "0" mark is
directly under the red line on the pointer window
(A), if any deviation occurs, loosen the knob (C),
micro-adjust the pointer window (A), so that the red
line on the window is over the "0" mark on the tape,
then secure the knob (C).
Fig. 13
B
11