HARVEY C300-30 Operating Instructions Manual page 13

5.4.2 Hand-wheel handle installation
Install the handle into the Blade Tilt hand-wheel as
shown in Fig. 7.
Fig. 7
5.4.3 Extension wings installation（Fig.8）
The machine is equipped with a cast iron extension
wing on each side of the main table. The mounting
bolts of extension wings are pre-mounted in the
threaded holes on the main table sides. Install the
extension wings as follows:
1. Remove the screws from the sides of the main
table;
2. Inspect the extension wings and main table
mating surfaces for burrs or foreign materials that
may inhibit assembly; the mating edges of the
tables must be clean and flat, use a wire brush or
sand paper if necessary to clean up the edges;
3. Attach the wings to the main table by using the
screws removed in step 1;
4. Use a straightedge to check whether that the
main table is coplanar with the extension wing. If
not, use a strip of masking tape to shim the
extension wing up or down, as directed by the
arrow in Fig. 8.
Fig. 8
5.4.4 Install the rail & fence
1. Install the rails and tube as breakdown shows.
Before tightening the rear rail, check to make sure
the top edge of the rear rail is lower than the T-slot
ensuring the miter gauge can slide smoothly when
installed later, as shown in Fig. 9.
Fig. 9
2. Install the fence on the rail on the right hand side
of the blade as shown in Fig. 10.
Make sure the cam foot contacts the cam on
the fence lock handle before you place the
fence on the rail, otherwise the fence can not
be placed well ( Fig. 10).
If you need to use the fence on the left side of
the blade, remove the knobs (A), as shown in
Fig.10, and move the fence plate and locking
bar to the right side of the fence body, secure
them on the left side of the fence body.
Fig. 10
3. Check the
perpendicularity
As shown in Fig.11, after securing the fence,
ensure that the fence is parallel to the miter slot,
which is parallel to blade at any locations. And
make sure that the distance L
which creates a slightly larger opening between the
10
fence parallelism
（ F ig.11 ）
>L , L
1 2
，
A
and
-L <1/64",
1 2