Table of Contents
Advertisement
CONNECTIONS
The connector on the rear of the Jackal has the following connection points available for use.
AVAILABLE CONNECTIONS
A1
GND (Ground/Earth/0V)
A2
IN13 (Prox/Reed/Switch/Alarm)
A3
IN12 (Prox/Reed/Switch/Alarm)
A4
IN11 (Prox/Reed/Switch/Alarm)
A5
IN10 (Prox/Reed/Switch/Alarm)
A6
IN9 (Prox/Reed/Switch/Alarm)
A7
IN8 (Varying volt sensor)
A8
Not Used
A9
Not Used
A10 RS232 Tx (Transmit)
A11 RS232 Rx (Receive)
^ B8/OUT1 is Open Circuit when the output is NOT ACTIVE, and is connected to GND when the
output is active
^^ B9/OUT2 will only power the sensors when the unit is turned on
Any Inputs 1-13 can be used as remote/run hold
AM-Jackal-2
B1
IN1 (1x Coil Input ONLY /Prox/Reed sensor)
B2
IN2 (Prox/Reed/Switch/Alarm)
B3
IN3 (Prox/Reed/Switch/Alarm)
B4
IN4 (Prox/Reed/Switch/Alarm)
B5
IN5 (Prox/Reed/Switch/Alarm)
B6
IN6 (Prox/Reed/Switch/Alarm)
B7
IN7 (Varying volt sensor)
B8
Out1 (Solenoid/Shutoff/Pulse/Radar output ) – Pulls to GND
^
B9
Out2 (+12V Supply Out) – Sensor Power ^^
B10
BATT
+VE
B11
BATT -VE (0V/GND Battery Terminal, Vehicle Ground)
more quick guides @ www.farmscanag.com/jackal
(+12V Battery Terminal)
Connections
3
July 2013
Advertisement
Table of Contents
