Table of Contents
Advertisement
Loading Series 8200 CNC Pal
Programs
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Wait for tape motion to stop. Both indicators should be off.
9.
Remove the data cartridge and position the record protect tab to the
right.
Recording a C Version PAL Program
Use the following procedure to store a C version PAL program on the data
cartridge recorder:
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 9600 baud. Set the TRACK
SELECT switch to track 1 or track 2.
3.
Set the power ON/OFF switch to the ON position.
4.
Be sure that the write protect tab on the data cartridge is positioned
to the left, and insert the cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operation.
NOTE: If the recorder is turned off while a tape rewind operation is in
progress, the data on the tape will be altered.
6.
Select the KYBD (keyboard) mode.
7.
Enter the following command through the keyboard: AL,PN,C,CA].
8.
Wait for the RECORD ON TAPE indicator to turn on. After a short
delay the DATA IN indicator turns on.
Wait for tape motion to stop. Both indicators should be off.
9.
Remove the data cartridge and position the record protect tab to the
right.
Use the following procedure to load a PAL program from a data cartridge
into the control's memory:
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 9600 baud. Select the track
containing the desired program.
3.
Set the power ON/OFF switch to the ON position.
4.
Insert the data cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operation.
Chapter 4
Operation
4 21
Advertisement
Table of Contents
