Table of Contents
Advertisement
Chapter 4
Operation
4 8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[A] - Causes the area shown on the industrial terminal CRT monitor as the
CURRENT ADDRESS to be recorded on tape. If the prompt DUMP
SYSTEM is displayed, and no CURRENT ADDRESS is shown, all user
accessible memory is recorded.
[Y] - Causes the next lower level of memory to be displayed as the
CURRENT ADDRESS.
[U] - Causes the next higher level of memory to be displayed as the
CURRENT ADDRESS.
[N] - Advances the CURRENT ADDRESS one number at the same level.
[E] - Used to end files and to verify the tape.
Following are procedures for recording all user accessible memory and
for recording the user's program and assistance (HELP) messages only.
Other areas of memory are recorded in a similar manner.
Recording All User Accessible Memory
Use the following procedure to record accessible PLC-3 memory.
NOTE: The mini data cartridge is limited to 144K words of data.
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 9600 baud. Set the TRACK
SELECT switch to the continuous (CONT) position.
3.
Set the power ON/OFF switch to the ON position.
4.
Be sure that the write protect tab on the data cartridge is positioned
to the left, and insert a data cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operation .
6.
Type [D][U][M][P][ENTER] on the industrial terminal keyboard.
7.
Respond to prompts for tape and file names.
8.
Respond to the prompt DUMP SYSTEM by typing [A][ENTER] on
the industrial terminal keyboard.
9.
Wait for the RECORD ON TAPE indicator to turn off and the tape to
stop.
10. Type [E][ENTER] on the industrial terminal keyboard.
Advertisement
Table of Contents
