Table of Contents
Advertisement
Verifying Series 7100 CNC
Programs
Recording Series 8200 CNC Part
Programs
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The procedures for recording and loading include steps for verifying the
programs. you can also verify programs at other times by using the
following procedure:
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 1200 baud. Select the track
containing the desired program.
3.
Set the power ON/OFF switch to the ON position.
4.
Insert a data cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operation.
6.
Place the cursor on the first program instruction.
7.
Press [RECORD][1] on the industrial terminal keyboard.
8.
Press the READ FROM TAPE switch on the recorder.
9.
Wait for the READ FROM TAPE indicator to turn off and the tape to
stop.
10. If errors are found, a message will appear on the industrial terminal
CRT monitor.
NOTE: If using a 1770-T3 industrial terminal system, steps 7-9 can be
replaced by pressing [RECORD][SHIFT][C] on the keyboard.
NOTE: The data table is compared only on the first verification, and
only if the mode select keyswitch is left in the PROG position. If it is not
necessary to verify the data table, the mode select keyswitch can be in any
position.
You can record Series 8200 CNC part programs that are stored in main
memory or punched tape on the data cartridge recorder. The program to
be recorded does not have to be active at the time of the data transfer.
Recording Part Programs from Memory
Use the following procedure to record programs from the control's
memory:
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 9600 baud. Set the TRACK
SELECT switch to track 1 or track 2.
3.
Set the power ON/OFF switch to the ON position.
Chapter 4
Operation
4 15
Advertisement
Table of Contents
