Table of Contents
Advertisement
Chapter 4
Operation
Loading Series 7100 CNC
Program
4 14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
13. Press the READ FROM TAPE pushbutton.
14. If errors are indicated, repeat the record operation.
15. When finished recording, remove the data cartridge and position the
record protect tab to the right.
NOTE: If using a 1770T3 industrial terminal system, steps 8-13 can be
replaced by pressing [RECORD][SHIFT][B] on the keyboard.
When loading Series 7100 CNC programs, use the following procedure:
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 1200 baud. Select the track
containing the desired program.
3.
set the power ON/OFF switch to the On position.
4.
Insert a data cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operation.
6.
Place the mode select switch on the programmable interface (PI)
module in the LOAD (up) position.
7.
Press [RECORD][0] on the industrial terminal keyboard.
8.
Press the READ FROM TAPE pushbutton on the recorder.
9.
Wait for the industrial terminal CRT monitor to display the prompt
REWIND TAP AND PRESS READ FROM TAPE/PLAY.
10. Press the STOP/REWIND pushbutton on the recorder.
11. Wait for tape motion to stop.
12. Press the READ FROM TAPE pushbutton on the recorder.
13. If errors are indicated, either repeat the load operation or locate and
correct the errors.
14. If an error message appears, type [SEARCH][9] to display the
number of errors found.
15. If the number of errors is 19 or less, the location of each error found
can be displayed by typing [SEARCH] followed by the number of
the error. For example, the first error found is displayed when
[SEARCH][0][1] is typed, while the fifth error found is displayed
when [SEARCH][0][5] is typed.
NOTE: If using a 1770-T3 industrial terminal system, steps 7-12 can be
replaced by pressing [RECORD][SHIFT][A] on the keyboard.
Advertisement
Table of Contents
