Table of Contents
Advertisement
Chapter 4
Operation
4 16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4.
Be sure that the write protect tab on the data cartridge is positioned
to the left, and insert a data cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operations.
NOTE: If the recorder is turned off while a tape rewind operation is in
progress, the data on the tape will be altered.
6.
Select the KYBD (keyboard) mode.
7.
Enter the following command through the keyboard: CS, CY, name,
CA]. "Name" is the program name in memory.
8.
Wait for the RECORD ON TAPE indicator to turn on. After a short
delay the DATA IN indicator turns on.
Wait for tape motion to stop. Both indicators should be off.
NOTE: If the recorder stops unexpectedly and either the DATA IN or
RECORD ON TAPE indicator is on in addition to the ERROR indicator,
turn the recorder off and then on again. Press the READER RESET key.
Repeat the recording operation.
9.
When finished recording, remove the data cartridge and position the
record protect tab to the right.
Recording Part Programs from Punched Tape
Use the following procedure to record programs stored on punched tape:
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 9600 baud. Set the TRACK
SELECT switch to track 1 or track 2.
3.
Set the power ON/OFF switch to the ON position.
4.
Be sure that the write protect tab on the data cartridge is positioned
to the left, and insert a data cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operation.
NOTE: If the recorder is turned off while a tape rewind operation is in
progress, the data on the tape will be altered.
6.
Position the tape containing the program to be copies on the tape
reader. Bypass the man-readable leader.
7.
Select the KYBD (keyboard) mode.
Advertisement
Table of Contents
