Tono-Vera Vet Training Aid - Ametek Reichert Tono-Vera Vet Instructions For Use Manual

Instructions for Use

Tono-Vera Vet Training Aid

The included Training Aid allows users to become familiar with the
operation of Tono-Vera Vet. The Training Aid is designed to simulate
the experience of aligning the device using the ActiView Positioning
System to take measurements.
Turn Tono-Vera Vet on and install a new Ocu-Dot Probe.
1 1
Hold the Training Aid in the palm of your hand. Using the on-screen
2
ActiView Positioning System, slowly align Tono-Vera Vet so the
Ocu-Dot Probe tip is centered over the training eye, and at the correct
distance. The alignment ring and level indicators will turn green when
the device is properly aligned for both distance, centration, and probe
angle. Refer to the Positioning, Aligning, and Measuring sections of this
manual for detailed instructions.
After a successful measurement, the Final IOP Result will read ">99"
3
and briefly appear in a large orange ring, indicating a successful
Training Aid measurement. After, the orange ring and ">99" will appear
in the selected eye as the Final IOP Result for that eye.
NOTE: The Training Aid eye is a hard material, and the IOP value will
always read as greater than 99. Any IOP measurement over 99
will appear as ">99" and appear in an orange ring.
At any point, measurements can be cleared by pressing Clear (×).
4
Practice taking IOP measurements with the Training Aid as many
5
times as desired.
After practice measurements are finished, dispose of the Ocu-Dot
6
Probe by ejecting it into the Probe Tube. Refer to the Ocu-Dot Probe
Installation section of this manual for more detailed instructions on
disposing the Ocu-Dot Probe.
NOTE: The Training Aid may not work well in very bright environments.
(continued)
1
3
>99
2
Approx. 6 mm
16308-101 Rev. A • 20