Linhai LH1100U-D Service Manual page 65

CHAPTER 6 TRANSMISSION
Fig 37
h Mount the bearing I to its limit stop
→Fig 38(page 8).
Fig 38
Table 2.Intermediate Shaft
Components
A Bearing Ⅰ
B Intermediate Shaft
C Roller cage Ⅰ
D Speed reduction gear
E Clearance washer Ⅰ
F Safety snap ring Ⅰ
G Engagement Ⅰ
H
Waveform spring
I
Clearance washer Ⅱ
J
Roller cage Ⅱ
K Slow gear running gear
L
Clearance washer Ⅲ
M Reverse gear
N Safety snap ring Ⅱ
O engagement Ⅱ
P engagement Ⅲ
Q Bearing Ⅱ
→Fig 39(page 8).
LH1100U-D SERVICE MANUAL 2019.0
Fig 39
Note: During the assembly, it is not
necessary to adjust the components. All
the swivel rings and the clearances have
been calculated
4. Mount the following components in
sequence on the intermediate shaft.
a The assembled baring A
b The Roller cageⅠC
c Speed reduction gear D, with the
convexity for gear at the top.
→Fig 40(page 8).
Fig 40
d The Clearance washer Ⅰ E
e The Safety snap ring Ⅰ F
→Fig 41(page 8).
Fig 41
CHAPTER 6 TRANSMISSION. 6- 10