Check Points Of Every 200 Hours - Linhai LH1100U-D Service Manual

05-E4B, 05-E4BG SERIES, WSM

[5] CHECK POINTS OF EVERY 200 HOURS

Changing Engine Oil
CAUTION
• Be sure to stop engine before changing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick.
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
• Never mix two different types of oil.
• Engine oil should have properties of API classification.
(See page G-6.)
• Use the proper SAE Engine Oil according to ambient
temperature.
• Upon an oil change, be sure to replace the gasket with new
one.
Above 25 °C (77 °F)
0 °C to 25 °C (32 °F to 77 °F)
Below 0 °C (32 °F)
Models
D1005-E4B/E4BG,
D1105-E4B/E4BG
D1305-E4B/E4BG
V1505-E4B/E4BG
Drain
plug with
copper
gasket
Tightening torque
Drain
plug with
rubber
coated
gasket
(1) Drain Plug
G-14
SAE 30 or
SAE 10W-30, SAE 10W-40
SAE 20 or
SAE 10W-30, SAE 10W-40
SAE 10W or
SAE 10W-30, SAE 10W-40
Oil Pan Depth
110 mm 125 mm
(4.33 in.) (4.92 in.)
5.1 L
–
1.3 U.S.gals
5.7 L
–
1.5 U.S.gals
– –
33 to 37 N·m
M12 × 1.25 3.3 to 3.8 kgf·m
24 to 27 lbf·ft
45 to 53 N·m
M22 × 1.5 4.5 to 5.5 kgf·m
33 to 39 lbf·ft
9Y1210784GEG0009US0
GENERAL
130 mm
(5.12 in.)
–
–
6.7 L
1.8 U.S.gals
KiSC issued 03, 2019 A