Rear Stabilizer Bar Removal/Installation; Box Removal/Installation - Linhai LH1100U-D Service Manual

CHAPTER 3 CHASSIS
Upon A-arm installation completion, test vehicle at low speeds before putting into regular
service.

3.3 REAR STABILIZER BAR REMOVAL/INSTALLATION

1. Elevate and safely support vehicle with weight
removed from the rear wheel(s).
2. Remove the rear wheel to gain access to the
stabilizer bar, each side.
3. Remove the stabilizer bar nut from the lower A-arm,
each side.
4. Remove the two bolts that secure the stabilizer bar to
the main frame, each side.
5. Remove the stabilizer from the frame.
6. Inspect the stabilizer bar. Inspect the bushings and
replace if needed.
7. Reverse the procedure for installation. Torque the
stabilizer bolts to 18 ft.lbs (25 Nm).

3.4 BOX REMOVAL/INSTALLATION

Box Removal
1. Disconnect the light coupler.
2. Lift the box into the dump position.
3. Remove the box shock pin from the frame (both
sides).
4. Remove the shocks from the shock brackets. Let
the shocks fully extend.
5. Remove the cotter pin from the hinge pin.
Remove the hinge pin (both sides).
CAUTION: Safely support the box during the rest the
removal process. The box is not as stable with the
LH1100U-D SERVICE MANUAL 2019.0
CHAPTER 3 CHASSIS
5
PAGE. 3-