General Precautions - Linhai LH1100U-D Service Manual

05-E4B, 05-E4BG SERIES, WSM

2. GENERAL PRECAUTIONS

• When you disassemble, carefully put the parts in a clean area
to make it easy to find the parts.
You must install the screws, bolts and nuts in their initial position
to prevent the reassembly errors.
• When it is necessary to use special tools, use KUBOTA special
tools. Refer to the drawings when you make special tools that
you do not use frequently.
• Before you disassemble or repair machine, make sure that you
always disconnect the ground cable from the battery first.
• Remove oil and dirt from parts before you measure.
• Use only KUBOTA genuine parts for replacement to keep the
machine performance and to make sure of safety.
• You must replace the gaskets and O-rings when you assemble
again. Apply grease (1) to new O-rings or oil seals before you
assemble.
• When you assemble the external or internal snap rings, make
sure that the sharp edge (3) faces against the direction from
which force (2) is applied.
• Make sure that you try to operate the engine after you repair or
assemble it.
(1) Grease
(2) Force
(3) Sharp Edge
G-4
GENERAL
(A) External Snap Ring
(B) Internal Snap Ring
9Y1210784GEG0004US0
KiSC issued 03, 2019 A