1MRK 511 243-UEN A
Section 1
1.1
This manual
The communication protocol manual describes a communication protocol supported by the
IED. The manual concentrates on vendor-specific implementations.
1.2
Intended audience
This manual addresses the communication system engineer or system integrator responsible
for pre-engineering and engineering for communication setup in a substation from an IED
perspective.
The system engineer or system integrator must have a basic knowledge of communication in
protection and control systems and thorough knowledge of the specific communication
protocol.
1.3
Product documentation
1.3.1
Product documentation set
IEC07000220 V1 EN-US
Figure 1:
IEC 60870-5-103, 650 series
Communication protocol manual
Introduction
Engineering manual
Engineering manual
Engineering manual
Installation manual
Installation manual
Installation manual
Commissioning manual
Commissioning manual
Commissioning manual
Operation manual
Operation manual
Operation manual
Service manual
Service manual
Service manual
Application manual
Application manual
Application manual
Technical manual
Technical manual
Technical manual
Communication protocol
Communication protocol
Communication protocol
manual
manual
manual
The intended use of manuals in different lifecycles
© Copyright 2011 ABB. All rights reserved
Section 1
Introduction
GUID-AB423A30-13C2-46AF-B7FE-A73BB425EB5F v11
GUID-C9B8127F-5748-4BEA-9E4F-CC762FE28A3A v6
GUID-3AA69EA6-F1D8-47C6-A8E6-562F29C67172 v9
en07000220.vsd
5