Led Status Indicators - Ixon IXrouter3 Installation Manual

4.3 LED status indicators
The IXrouter has two LEDs located right above the LAN ports. These show
the current status of the IXrouter's connection. The upper LED indicator (
displays the signal status, only applicable for 4G/Wi-Fi variants, and the
lower LED indicator (ACT) shows the activity status. The table below
provides an overview of all possible LED status indications.
Signal LED
ACT​ Activity LED
More info
For a list of most common causes and troubleshooting tips we recommend viewing our online
article about ​ L ED Status indicators​
www.ixon.cloud
Blinking blue
Blinking red 1 pulse
Blinking red 2 pulses
Blinking red 4 pulses
Constant red
Constant purple
Constant blue
Constant red
Blinking red 1 pulse
Blinking red 3 pulses
Blinking red 4 pulses
Blinking red 5 pulses
Blinking blue 1 pulse
Blinking blue 2 pulse
Constant blue
.
Initializing cellular module
No reception or unable to connect to
network
(APN or SSID may be incorrect)
PIN invalid or PUK required
(a phone is required to unlock SIM card
with PUK)
SIM card is invalid or missing
Connected, poor reception
Connected, medium reception
Connected, good reception
Booting up (may take 1-2 min) or not yet
registered
Waiting for internet access
LAN/WAN conflict
(conflicting subnets)
Removed from the platform
(re-insert USB flash drive to register
again)
Previously registered to the IXON Cloud
(remove from the IXON Cloud and
register again)
Connecting to the IXON Cloud
Setting up a VPN connection
Active VPN connection to the IXON
Cloud
)
13