Page 1
CP-EMW Series Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
Page 2
CP-EMW Series Installation Instructions Wall Mount Fig. 1 (A) x4 1. Remove the lens cover by loosening the (4) #8-32 x 3/8” screws (A) and #8-32 x 3/8” set aside. (Fig. 1) Lens Cover 2. Remove the housing by loosening the (2) #8-32 x 1/4“ screws (B) and set aside.
Page 3
CP-EMW Series Installation Instructions Pole or I-beam Mounting (Option) Fig. 4 POLE OR I-BEAM MOUNTING Note: The universal bracket is an accessory and needs to be ordered separately. Backplate Conduit Access Plug 1. Follow steps 1-4b under Wall Mount. Universal 2.
Page 4
CP-EMW Series Installation Instructions Self-Test/Self-Diagnostics (G2) Operation The purpose of this option is to provide Self-testing and Self-diagnostic capabilities to the emergency unit. At predeter- mined intervals, the emergency unit will automatically switch into battery mode. Refer to the Self-Test Feature section below for timing details.