Advertisement
Quick Links
Advertisement
Related Manuals for RH Baby&child Airin Spindle Crib
Summary of Contents for RH Baby&child Airin Spindle Crib
- Page 1 1 1 /...
- Page 2 IMPORTANT SAFETY INFORMATION FOR CRIBS WARNING: Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional padding under an infant. WARNING: Failure to follow these warnings and the assembly instructions could result in serious injury or death. ·...
- Page 3 IMPORTANT SAFETY INFORMATION FOR CRIBS CAUTION: ANY MATTRESS USED IN THIS CRIB SHALL BE AT LEAST 27 1/4" X 51 5/8" WITH A THICKNESS NOT EXCEEDING 6". WARNING Do not use this crib if you cannot exactly follow the instructions provided.
- Page 4 IMPORTANT SAFETY INFORMATION FOR TODDLER AND DAYBEDS WARNING: ENTRAPMENT / STRANGULATION HAZARD Infants have died in toddler beds from entrapment and strangulation. Failure to follow these warnings and the assembly instructions could result in serious injury or death. NEVER use bed with children under 15 months of age. NEVER place bed near windows where cords from blinds or drapes may strangle a child.
-
Page 5: Parts Identification
PARTS IDENTIFICATION For ease of identification, all parts are labeled to correspond to the step number in which the part is used. Step 1 Leg and end panel assembly End panel and stationary side rail assembly (Page 6) Step 2 Mattress support arm assembly Stabilizer rail assembly Mattress height adjustment (Page 7) - Page 6 STEP 1 LEG AND END PANEL ASSEMBLY STATIONARY DETAIL A SIDE RAIL AND END PANEL ASSEMBLY STEP 1.1 Gently lay the end panels on their backs on a clean and non-abrasive surface. STEP 1.2 Align and insert the threaded rod of the legs into the holes on the bottom of the end panels and turn clockwise to tighten.
- Page 7 STEP 2 MATTRESS SUPPORT ARM ASSEMBLY STABILIZER RAIL ASSEMBLY Allen Bolt (D) MATTRESS HEIGHT ADJUSTMENT STEP 2.1 Lay mattress support flat with stabilizer rail on each side. NOTE: On each end of the arm of the mattress support, there is a hole for the bolt to pass through that corresponds to the holes located Allen Bolt (D) in the frame of the mattress support.
- Page 8 STEP 3 INSTALLATION OF STABILIZER RAILS INTO DETAIL E THE END PANELS STEP 3.1 On inside face of both end panels are pre-installed metal brackets, designed to hold the stabilizer rails. Set both ends of the stabilizer rails into brackets, as illustrated in DETAIL E.
- Page 9 STEP 4 DETAIL H TODDLER RAIL ASSEMBLY STEP 4.1 Gently tilt the crib and release the bolts underneath the metal brackets holding the stabilizer rails. NOTE: · When converting to toddler bed, loosen all the bolts and nuts that connect the end panel and stationary side rail. See DETAIL H. ·...