Advertisement
top of the tripod,
5.2
Check and adjust the 3 levelling screws to be at mid-height of their travel,
5.3
Adjust the 3 levelling screws so the level bubble on the instrument is central,
6. Turn on EDM instrument.
6.1
Turn on and wait for Main Menu to load,
6.2
Check battery status,
"Protocols for use of the memory card are yet to be developed",
6.3
Set digital level
6.3.1
6.3.2
6.3.3
6.3.4
7.
Set the Check Marker
7.1
Throwing Events
Place the Check Marker just inside the sector line between 25m and 30m from the foul line
7.2
Horizontal Jumps
Place the Check Marker outside of the far end of the pit away from the take-off board
8.
Setup for EDM use.
SYSTEM 1100, SYSTEM 1200
●
Choose Programs from the 'Main Menu' Press #2
●
Choose 'Athletics Measurements'
●
Select event
9.
Setup for events.
9.0.1
After selecting the event of choice the instrument will ask you if;
"you want to use last definition of centre point and foul line as valid?"
9.0.2
Select
9.0.3
Select
not been moved and it is a continuation of the same event or the same event but with a different
C:\Neil\Athletics\EDM\EDM setup instructions.docx
02/03/2017
Press 'shift' on - (System 1100 located below F5 and (System 1200), or 'Fn' (Viva TS15)
Then Press F12 on - (System 1200) and (Viva TS15), and the spirit level button located below
F2 on (System 1100)
Adjust screen bubble level by turning the 3 adjusting screws to centralise the bubble and get
the lowest possible 'tilt L' and 'tilt R' numbers. Note: Wind can make this operation difficult to
achieve constant numbers. The target is 0.010 or lower.
When satisfied press 'Continue' (F1)
Press #6
Enter
'NO' for a new setup,
'YES' for using the existing setup if the instrument has not been moved, the check marker has
●
Will automatically go straight to Athletics
Measurements
Or
●
Select 'Go to Work'
●
Select 'Survey +'
●
Select page with 'Athletics Measurements'
●
Select event
4
VIVA TS15
Press OK
Press OK
Press OK
Press OK
Advertisement
