Steaming; General Program Information; Preparation Of The Steamer Attachments; Starting The Steaming Process - Silvercrest MONSIEUR CUISINE CONNECT Operating Instructions Manual

__317552_MC-Connect_GB.book Seite 23 Donnerstag, 21. März 2019 10:53 10

12. Steaming

DANGER! Risk of injury through scalding!
When opening the lid 1 or 23 during operation, hot
steam may escape.
NOTE: these user instructions describe the basic functions
such as mixing, chopping and steaming. For information
on the preparation of special dishes, refer to the recipe
book included in the delivery and in the device.

12.1 General program information

- Preset time: 20 minutes (adjustable),
maximum time: 60 minutes
- Preset temperature: 120 °C (fixed)
- Speed: off, not selectable
- heating up is displayed in the middle display dial.
- You can skip the heating time.
- Steaming has begun:
- heating up has gone out.
- The lower time display will show 20 minutes or your
chosen time.
12.2 Preparation of the steamer
attachments
1. Place the blender jug 5 into the holder 11.
2. Fill 1 litre of water into the blender jug 5. This corre-
sponds with the second marking from the bottom (I).
3. Check that the seal 4 for the deep steamer attach-
ment 3 has been placed correctly.
4. Place the deep steamer attachment 3 slightly twisted
onto the blender jug 5.
5. Turn the deep steamer attachment 3 so that it clicks
into place and an acoustic signal is heard.
The program can only be started if the steamer at-
tachment 3 is set correctly.
NOTE: in order to facilitate the attaching of the steamer
attachment 3 somewhat, put a few drops of oil on a cloth
and rub it on the seal 4.
6. Put the food into the steamer attachment 3 and (if
necessary) 2.
NOTES:
• Even if you only need the shallow steamer attach-
ment 2, always both steamer attachments 3 and 2
must be inserted, so that no steam can escape to the
side.
• Notes on the seal 4: (see "Deep steamer attach-
ment 3" on page 32).
7. Place the filled steamer attachment 2 onto the steam-
er attachment 3.
8. Close the steamer attachments using the lid for the
steamer attachments 1.

12.3 Starting the steaming process

1. The device is switched on and shows the start menu.
2. Press the button to enter the automatic programs
menu and then the STEAMING 41 and ---> buttons.
The values for the program appear in the three dis-
play dials.
Auto Recipes
20:00 0
STEAMING
Turbo Anti-clockwise
NOTE: you can change the values for the time. Tap the
time display dial and adjust directly with the display dial
or the control dial.
3. Press the  33 button. The heating time will start.
During this time
- heating up appears in the middle display dial.
- Press skip if you want to skip the heating time.
4. After the heating time has elapsed, the program
starts.
- heating up is extinguished and the speed setting 0
appears.
The lower time display shows 20 minutes or the se-
lected time.
Settings
120
°C
0
Weighing
GB
23