Put On The Lid Of The Blender Jug; Use The Lid For The Filler Opening; Cooking And Steaming With The Cooking Pot - Silvercrest SKMK 1200 A1 Operating Instructions Manual

BB&3(B(6ERRN 6HLWH  )UHLWDJ  -XQL   
10.5 Put on the lid of the
blender jug
The lid for the blender jug|32 can only be
placed on if the blender jug|5 was inserted
correctly.
1. Put the lid for the blender jug|32 slightly
twisted onto the blender jug|5.
The symbol of the opened lock points to
the arrow of the locking system|11.
2. Press and turn the lid|32 clockwise with
both hands until the closed lock symbol
points to the arrow of the locking sys-
tem|11.
Only when the lid|32 is correctly
closed, the device can start.
NOTES:
• In order to facilitate the closing of the lid
somewhat, put a few drops of oil on a
cloth and rub it on the seal|31.
• The device can only be started when the
lid|32 is put on correctly.
• To make the lid|32 properly lock in
place, it is helpful to press lightly on the
lock symbol while closing the lid.
• If the lid|32 has not been put
on correctly, the symbol
shown here on the right will
appear on the display|25.
52 GB
10.6 Use the lid for the filler
opening
Simultaneously, the measuring beaker|33 is
used to close the lid of the blender jug|5 and
to measure ingredients.
• In order to close the blender jug|5,
place the measuring beaker|33 with the
opening at the bottom into the lid|32
and lock it in place by turning it clock-
wise.
CAUTION:
~ Prior to removing the measuring beak-
er|33, you must reduce the speed to set-
ting 1, 2 or 3, so that no food can be
ejected.
• In order to fill in ingredients, the measur-
ing beaker|33 can be removed briefly.
• To measure ingredients, turn the measur-
ing beaker|33 upside down and fill in
the food. The values can be read in ml
from the outside.
10.7 Cooking and steaming
with the cooking pot
1. Fill at least 500 ml of water into the
blender jug|5. Only fill so much water
into the blender jug|5 that the maximum
filling volume of 2.2 litres will not be ex-
ceeded when the food is added.
- If the entire food is covered by water,
it will be cooked.
- If the food is not completely covered
by water, it will be steamed.
2. Fill food into the cooking pot|28.
NOTE: Always make sure that the filling lev-
el does not exceed the marking MAX.
3. Place the cooking pot|28 into the blend-
er jug|5.
4. Close the blender jug|5 with the lid|32
and the measuring beaker|33.