Using The Spatula; Removing The Blender Jug; Operating The Device; Power Supply - Silvercrest MONSIEUR CUISINE CONNECT Operating Instructions Manual

__317552_MC-Connect_GB.book Seite 14 Donnerstag, 21. März 2019 10:53 10

9.8 Using the spatula

The spatula 21 is used to stir the ingredients and to remove
the cooking pot 19.
CAUTION:
The spatula 21 must not be used with the mixer attach-
ment 20 in place. Otherwise, the spatula 21 might be
caught in the mixer attachment 20.
Do not use any other kitchen utensil to stir the ingredi-
ents. The utensil might get into the blades and cause
damage.
• Always stir clockwise. The spatula 21 is designed
such that when stirring clockwise it cannot come into
contact with the blade assembly 18 even if that is run-
ning.
• The hook on the rear of the spatula 21 can be used to
remove the hot cooking pot 19 without having to
touch it directly. Simply hook on the metal bracket of
the cooking pot 19 and pull it out upwards.
Tips for changing the tip and for cleaning: (see "Cleaning,
checking and replacing the spatula" on page 32).
GB
14

9.9 Removing the blender jug

DANGER! Risk of injury through burning!
If the contents of the blender jug 5 are hot, the lid 23
must be opened slowly and carefully.
The mass in the blender jug is still in motion immediate-
ly after puréeing and could spill out if the lid is opened
too quickly. Therefore, wait approx. 10 seconds after
puréeing before opening the lid.
1. Press and turn the lid 23 with both hands anticlock-
wise and then remove it.
2. Remove the blender jug 5 upwards.

10. Operating the device

For safety reasons, the settings described in this chapter,
can only be selected when the device has been assembled
completely.

10.1 Power supply

• Connect the mains plug 15 to a suitable wall socket.
The wall socket must still be easily accessible after con-
nection.
• Pull only as much cable as necessary out of the cable
compartment 16.

10.2 Switching the device on and off

NOTE: switching on for the first time is described in chap-
ter "Switching on for the first time and connecting to the In-
ternet" on page 7.
• Set the on/off switch 7 at the rear on the right to I:
- The touchscreen 8 lights up.
- After some time a signal sounds and the start menu
appears on the screen.
.
Auto Recipes
00:00 0
Turbo Anti-clockwise
• Set the on/off switch 7 on the back to 0 to switch the
device off.
Settings
0
°C
0
Weighing