Change Menu Language; Cleaning And Servicing The Device; Cleaning The Base Unit; Cleaning In The Dishwasher - Silvercrest MONSIEUR CUISINE CONNECT Operating Instructions Manual

__317552_MC-Connect_GB.book Seite 31 Donnerstag, 21. März 2019 10:53 10

16.9 Change menu language

If desired, you can change the language for the menus.
1. Tap the button on the screen.
2. If required, tap .
3. Slide the menu up with one finger and then press the
CHANGE field in the Language row.
4. Tap the field of the desired language and confirm the
selection.
The screen goes dark and then appears after a few
seconds with the new languages.
17. Cleaning and servicing the
device
DANGER! Risk of electric shock!
Disconnect the mains plug 15 from the mains socket
before any cleaning.
Never immerse the base unit 13 in water.
DANGER! Risk of injury from cutting!
Please remember that the blades of the blade assem-
bly 18 are very sharp. Never touch the blades with
your bare hands in order to avoid cuts.
Before removing the blade assembly 18, rinse the
blender jug 5 with water and remove scraps of food
from the blades so that the blade assembly 18 can be
removed safely.
When washing manually, the water should be suffi-
ciently clear so that you can see the blade assem-
bly 18 easily to avoid injuries caused by the very
sharp blades.
CAUTION:
Never use any abrasive, corrosive or scouring clean-
ing agents. These might damage the device.
NOTE: certain foods or spices (e.g. curry) may discolour
the plastic. This is not a device error and is harmless to
health.

17.1 Cleaning the base unit

1. Clean the base unit 13 with a damp cloth. You can
also use a little washing-up liquid.
2. Then wipe off with a clean, moist, light cloth with
clean water.
3. Do not use the base unit 13 until it is completely dry
again.
4. The screen can also be cleaned with a lens cleaning
cloth or special cleaning agents for monitors.

17.2 Cleaning in the dishwasher

The following parts are dishwasher-safe:
- Blender jug 5
- Measuring beaker 24
- Lid for blender jug 23
- Seal for blender jug 22
- Blade assembly 18
- Seal for blade assembly 17
- Cooking pot 19
- Mixer attachment 20
- Spatula 21
- Steamer attachment, deep 3
- Seal for the steamer attachment 4
- Steamer attachment, shallow 2
- Lid for the steamer attachments 1
The following parts must never be cleaned in a dishwasher:
- Base unit 13
NOTE: before cleaning the blender jug 5 in the dishwash-
er, always remove the blade assembly 18.

17.3 Cleaning the accessories

1. Rinse the blender jug 5 with warm water and dump
the water.
2. Remove the blade assembly 18 (see "Using and re-
moving the blade assembly" on page 12) and take
the seal 17 off (see "Cleaning, checking and replac-
ing seals" on page 31).
3. Clean all accessories by hand in a sink with dishwa-
ter or in the dishwasher.
4. When cleaning by hand, rinse all parts with clean
water.
5. Allow the parts to dry completely before using them
again.
6. Before using the device again, reinsert the blade as-
sembly 18 in the blender jug 5.
17.4 Cleaning, checking and
replacing seals
Remove seals 17, 22 and 4 for cleaning and check them
for damage. Pay attention to changes (e.g. porous materi-
al or tears).
- The removed seals 17, 22 and 4 can be cleaned in
the dishwasher.
- Damaged seals 17, 22 and 4 must be replaced with
new ones. You can reorder new seals (see "How to or-
der accessories" on page 34).
CAUTION:
Prior to the next use, damaged seals 17, 22 and 4
must be inserted again or replaced with new ones. An
operation without seals 17, 22 and 4 in place is not
permitted.
GB
31