Mounting: Where Do I Mount/Position My Sensor; Where To I Place My Station; Time: Does This Station Have Atomic Time; How Do I Manually Set The Time - La Crosse Technology CA76669 Faqs

MOUNTING: WHERE DO I MOUNT/POSITION MY SENSOR?

• Watch sensor mounting video:
• Place your thermo-hygro sensor at least 6 feet off the ground.
• For accurate temperature readings your sensor needs to be shaded from the sun and in a
well ventilated area. Trapped moisture will cause inaccurate readings.
• Mount your sensor vertically to allow moisture to drain out the bottom.
• Preferred location is on a north facing wall under an eave or deck rail.
• Avoid placing near a metal roof that will cause it to read high on sunny days.
• Avoid other sources of heat such as soffit vents, and window or door frames.
• For accurate humidity readings, avoid placement near vegetation and lakes or other bodies
of water when possible.
• Maximum transmission distance from your thermos-hygro sensor to your station, in open air
is 330 feet (100 meters).
• Insert the mounting screw through the front of the transmitter and into the wall. Tighten the
screw to snug (do not over tighten).
Your station is designed for flexible placement on a desk or countertop, or to position on the
wall. When the stand is closed, it provides wall mounting holes.
• Position within reach of an outlet that is always active. Some outlets in living rooms and in
bedrooms may only be active when the light switch is on.
• Best reception occurs when only one wall is between your station and each sensor outside.
• Position you station six feet from other electronics and wireless devices. If you suspect RF
(radio frequency) interference, simply move your weather station a few feet.

TIME: DOES THIS STATION HAVE ATOMIC TIME?

No, Time and Date are manually set.
Note: Only press or hold one button at a time.
1. Hold the SET button 2 seconds to enter settings mode.
2. Press the OUT/+ or - button to adjust the flashing values.
3. Hold the OUT/+ or - button to adjust quickly.
4. Press the SET button to confirm adjustments and move to the next item.
5. Press the LIGHT button at any time to exit.
http://bit.ly/TH_SensorMounting

WHERE TO I PLACE MY STATION?

HOW DO I MANUALLY SET THE TIME?

3 | P a g e