Table of Contents
Advertisement
TX14R:
•
Mount your rain sensor in an open area for a more accurate rain count.
•
Placing the rain sensor on the ground provides the most accurate rainfall measurement as
there is no wind shear. Unfortunately, since insects think of rain gauges as personal hotels,
placing the sensor 3-6 feet above ground may deter the insects.
•
Be sure your rain sensor is not sitting in a depression that would prevent rain from draining
form the sensor properly.
•
Your rain sensor should be accessible to allow for periodic cleaning of leaves or other
debris that may clog the funnel.
•
Install the Rain sensor on a level platform that is stationary and has a direct line of sight to
your station.
•
Insert mounting screws through the holes in the base of the rain sensor. Do not over tighten.
•
Avoid other wireless rain sensors, as this can cause inaccuracy.
•
The maximum wireless transmission range to the rain station is over 300 feet (91 meters) in
open air, not including walls or floors.
Your station is designed for placement on a desk or countertop, or wall mounted.
•
Best reception occurs when only one wall is between your station and your sensor outside.
•
Position you station six feet from other electronics and wireless devices. If you suspect RF
(radio frequency) interference, simply move your station a few feet.
WHAT IS DISTANCE | RESISTANCE | INTERFERENCE?
Distance:
•
The maximum transmitting range in open air is over 300 feet (91 meters) between your
sensor and your station.
•
Consider the signal path from your station to your sensor as a straight line.
•
Consider the distance the station is from other electronics in the home.
Resistance:
•
Each obstacle: walls, windows, vegetation, stucco, concrete, and large metal objects will
reduce the effective signal range by about one-half.
•
Mounting your sensor on a metal fence can significantly reduce the effective signal range.
Interference:
•
Consider electronics in the signal path between the sensors and your station.
•
Simple relocation of the sensors or the station may correct an interference issue.
•
Windows can reflect the radio signal.
•
Metal will absorb the RF (radio frequency) signal.
•
Stucco held to the wall by a metal mesh will cause interference.
•
Transmitting antennas from: ham radios, emergency dispatch centers, airports, military
bases, etc. may cause interference.
•
Electrical wires, utilities, cables, etc. may create interference if too close.
WHERE TO I PLACE MY STATION?
3 |
P a g e
Advertisement
Table of Contents
