8.1
System Status
The first selection, System Status gives you information on the status and statistics of the ports, as shown
below. System Status is a tool that can be used to monitor your Prestige. Specifically, it gives you
information on your ISDN telephone line status, number of packets sent and number of packets received.
To get to the System Status, enter 24 to go to Menu 24 - System Maintenance. From this menu, enter 1,
System Status. There are five commands in Menu 24.1 - System Maintenance - Status. Entering 1
disconnects the current B1 channel call; 2 disconnects the current B2 channel call, 3 resets the counters, 4
drops both B1 and B2 and ESC takes you back to the previous screen.
The table below describes the fields present in Menu 24.1 - System Maintenance - Status. It should be
noted that these fields are READ-ONLY and are meant to be used for diagnostic purposes.
Chan
Link
--
Down
--
Down
Chan
Own IP Address
--
--
Ethernet Status
Down
Total Outcall Time:
LAN Packet Which Triggered Last Call:
COMMANDS: 1-Drop B1
The following table describes the fields present in Menu 24.1 - System Maintenance - Status.
8-2
Menu 24.1 -- System Maintenance – Status
Type
TXPkts
RXPkts
0Kbps
0
0Kbps
0
Own CLID
TX Pkts
RX Pkts
4
0:00:00
Press Command:
2-Drop B2
Figure 8-2 Menu 24.1 - System Maintenance – Status
Errors
CLU
0
0
0
0
Peer IP Address
Collision
0
0
3-Reset Counters
4-Drop All
Prestige 201 ISDN Access Router
ALU
Up Time
0%
0%
0:00:00
0%
0%
0:00:00
Peer CLID
ESC-Exit
System Maintenance