Figure 5-2 Menu 12 - Ip Static Route Setup; Figure 5-3 Edit Ip Static Route; Table 5-1 Edit Ip Static Route Menu Fields - ZyXEL Communications P-202 User Manual

To configure an IP static route, use Menu 12 - IP Static Route Setup, as displayed below.
From Menu 12, select one of the available IP static routes to open Menu 12.1 - Edit IP Static Route, as
shown next.
Field
Route Name
Active
Destination IP Address
IP Subnet Mask
5-2
Menu 12 - IP Static Route Setup
1. ________
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter selection number:

Figure 5-2 Menu 12 - IP Static Route Setup

Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name = ?
Active= No
Destination IP Address = ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:

Figure 5-3 Edit IP Static Route

Table 5-1 Edit IP Static Route Menu Fields

Enter a descriptive name for this route. This is for identification purpose only.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a route to a
single host, use a subnet mask of 255.255.255.255 in the subnet mask field to
force the network number to be identical to the host ID.
Enter the subnet mask for this destination. Follow the discussion on IP subnet
mask in this chapter.
Prestige 201 ISDN Access Router
Description
Static Route Setup