Advertisement
To prevent overheating, do not use for longer than 20 minutes at a time. Allow to
cool for 10 minutes before resuming use.
Charging and Battery Operation
To charge the wand, place it into the storage compartment in the main unit. Plug
the adaptor into the main unit and turn on at the wall socket.
Before using for the first time, allow the wand to be charged for at least 8 hours.
If the wand is fully charged the appliance should function for approximately 40
minutes in cordless mode.
To extend the life of the batteries, allow the wand to run down completely before
recharging.
Using your Nail Spa
-
You can switch on the wand by pushing the switch from 0 (OFF) to speed I
(one) or to speed II (two).
-
The speed of rotation can be changed by switching from speed I (one) to
speed II (two).
-
Choose the particular Attachment you wish to use, depending on the effect
you wish to achieve.
-
To put on a new attachment place over the top of the wand and push on
gently but firmly.
-
To remove an attachment, simply pull the attachment off.
-
To activate the nail bath and the nail dryer connect the adaptor to the unit.
The ON button for the nail bath and nail dryer are marked on the side of the
main unit.
-
Do not use the nail bath and nail dryer for more than 20 minutes at a time.
Advertisement
