Table of Contents
Advertisement
Care & Maintenance
10 Care & Maintenance
The miniIPS2 and 2e are remarkably robust, being primarily constructed of titanium. The only maintenance
required, other than periodic recalibration as necessary or recommended at maximum of 2 years, is to keep
the sensor as clean as possible. The instrument should be rinsed with freshwater when recovered and any
debris or growth gently removed.
Do not attempt to remove the acetal Lock Screw Cap from the Pressure Module. If debris is caught under
the cover attempt to remove it under slowly flowing water, use no tools. If this fails contact Valeport for
further advice. If the sensor diaphragm is damaged in any way it will have to be replaced.
The instrument should be stored in its box when not in use. It is not necessary to remove the
Interchangeable Pressure Sensor Module during storage.
Any damage to this diaphragm will render the Pressure Module warranty invalid
10.1 Calibration
The miniIPS2 and 2e Interchangeable Pressure Modules can be returned to Valeport or one of its approved
laboratories for recalibration.
Pressure sensors should be calibrated biennially
10.1.1 Secondary Calibration
If you would like to include your own calibration use the following # codes to set it up
# Code
#037;n
#022;user_coeff
Contact Valeport for more details on user calibrations
© 2020 – Valeport Ltd
Description
Enable \ Disable Secondary Calibration, where n =
0 = Disable
1 = Enable
Enter user calibration coefficients as follows: #022;c2;c1;c0
Page | 38
Advertisement
Table of Contents
