Table of Contents
Advertisement
Step 3: Install the VP-426C
Install VP-426C using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to www.kramerav.com/downloads/VP-426C.
•
Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/VP-426C).
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VP-426C. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the VP-426C.
Connect the audio output
To a balanced
stereo audio
acceptor:
Step 5: Connect the power
Connect the power cord to VP-426C and plug it into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the power cord that is supplied with the unit.
Warning:
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See
www.KramerAV.com
for updated safety information
Step 6: Operate and control the VP-426C
Select the input via the following options:
•
Press the front panel INPUT button.
•
Use the contact closure terminal block to select an input remotely with the
press of a button.
Press the MENU button to configure and control the device via OSD menu:
•
Set brightness, contrast, color, noise reduction etc.
•
Manage EDID.
•
Configure HDCP behavior.
•
Select resolution and aspect ratio.
•
Manage auto power down (Auto Sync Off).
•
Manage audio bypass and delay.
•
View device information.
•
Reset to factory default parameters.
•
Control OSD display.
To an
unbalanced
stereo audio
acceptor:
Advertisement
Table of Contents
Need help?
Do you have a question about the VP-426C and is the answer not in the manual?