Figure 36 Otist; Table 24 Otist; Reset Button; Web Configurator - ZyXEL Communications PRESTIGE 660H Series User Manual

7.9.1.1.1 Reset button

If you use the Reset button, the default (01234567) or previous saved (through the web
configurator) Setup key is used to encrypt the settings that you want to transfer.
Hold in the Reset button for one or two seconds.
Note: If you hold in the Reset button too long, the device will reset to the factory
defaults!

7.9.1.1.2 Web Configurator

Click WIRELESS LAN, OTIST to display the next screen.

Figure 36 OTIST

The following table describes the fields in this screen.

Table 24 OTIST

LABEL
Key
Yes!
Back
Start
Cancel
Chapter 7 Wireless LAN (Prestige 660HW)
DESCRIPTION
Enter the setup key up to eight printable characters. The default OTIST setup key is
"01234567".
Note: If you change the OTIST setup key here, you must also make the
same change on the wireless client(s).
To have OTIST automatically generate a WPA-PSK key, select this check box. If you
manually configured a WEP key or a WPA-PSK key and you also select this check box,
then the key you manually configured is used.
Click Back to go to the main wireless LAN setup screen.
Click Start to encrypt the wireless security data using the setup key and have the
Prestige set the wireless station to use the same wireless settings as the Prestige. You
must also activate and start OTIST on the wireless station at the same time.
The process takes three minutes to complete.
Click Cancel to begin configuring this screen again.
Prestige 660H/HW Series User's Guide
100