Otist; Table 24 Radius - ZyXEL Communications Prestige 660H Series User Manual

The following table describes the fields in this screen.

Table 24 RADIUS

LABEL
Authentication Server
Active
Server IP Address
Port Number
Shared Secret
Accounting Server
Active
Server IP Address
Port Number
Shared Secret
Back
Apply
Cancel

7.15 OTIST

OTIST (One-Touch Intelligent Security Technology) allows your Prestige to set the wireless
client to use the same wireless settings as the Prestige.
Note: The wireless client must also support OTIST and have OTIST enabled.
The following are the wireless settings that the Prestige assigns to the wireless client if OTIST
is enabled on both devices and the OTIST setup keys are the same.
• SSID
• Security (WEP or WPA-PSK)
Note: This will replace the pre-configured wireless settings on the wireless clients
Chapter 7 Wireless LAN Setup
DESCRIPTION
Select Yes from the drop-down list box to enable user authentication
through an external authentication server.
Enter the IP address of the external authentication server in dotted decimal
notation.
The default port of the RADIUS server for authentication is 1812.
You need not change this value unless your network administrator instructs
you to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be
shared between the external authentication server and the access points.
The key is not sent over the network. This key must be the same on the
external authentication server and Prestige.
Select Yes from the drop-down list box to enable user authentication
through an external accounting server.
Enter the IP address of the external accounting server in dotted decimal
notation.
The default port of the RADIUS server for accounting is 1813.
You need not change this value unless your network administrator instructs
you to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be
shared between the external accounting server and the access points.
The key is not sent over the network. This key must be the same on the
external accounting server and the Prestige.
Click Back to go to the main wireless LAN setup screen.
Click Apply to save these settings back to the Prestige.
Click Cancel to begin configuring this screen again.
Prestige 660H/HW Series User's Guide
100