Authentication Required: Wpa-Psk; Figure 33 Wireless Lan: 802.1X/Wpa:wpa-Pskl; Table 21 Wireless Lan: 802.1X/Wpa: Wpal-Psk - ZyXEL Communications PRESTIGE 660H Series User Manual

7.6.3 Authentication Required: WPA-PSK

Select Authentication Required in the Wireless Port Control field and WPA-PSK in the
Key Management Protocol field to display the next screen.

Figure 33 Wireless LAN: 802.1x/WPA:WPA-PSKl

The following table describes the labels not previously discussed.

Table 21 Wireless LAN: 802.1x/WPA: WPAl-PSK

LABEL
Key Management
Protocol
Pre-Shared Key
WPA Mixed Mode
Group Data Privacy
Authentication
Databases
Chapter 7 Wireless LAN (Prestige 660HW)
DESCRIPTION
Choose WPA-PSK in this field.
The encryption mechanisms used for WPA and WPA-PSK are the same. The
only difference between the two is that WPA-PSK uses a simple common
password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 printable characters (including spaces;
alphabetic characters are case-sensitive).
The Prestige can operate in WPA Mixed Mode, which supports both clients
running WPA and clients running dynamic WEP key exchange with 802.1x in the
same Wi-Fi network.
Select the check box to activate WPA mixed mode. Otherwise, clear the check
box and configure the Group Data Privacy field.
Group Data Privacy allows you to choose TKIP (recommended) or WEP for
broadcast and multicast ("group") traffic if the Key Management Protocol is
WPA and WPA Mixed Mode is disabled. WEP is used automatically if you have
enabled WPA Mixed Mode.
All unicast traffic is automatically encrypted by TKIP when WPA or WPA-PSK
Key Management Protocol is selected.
This field is only visible when WPA Mixed Mode is enabled.
Prestige 660H/HW Series User's Guide
96