Ftp File Transfer - ZyXEL Communications ZyXEL ZYWALL10 User Manual

COMMAND
Remote File
Binary
Abort
TFTP over WAN will not work if:
1. You have disabled Telnet service in menu 24.11.
2. You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet service.
3. The IP you entered in the Secured Client IP field in menu 24.11 does not match the client IP. If it
does not match, the ZyWALL will disconnect the Telnet session immediately.
4. You have an SMT console session running.
5. The firewall is active. The default firewall policies block all traffic from the WAN, so to enable TFTP
over the WAN, you must turn the firewall off (menu 21.2) or create a firewall rule to allow TFTP from
the WAN.

10.6 FTP File Transfer

In addition to uploading the firmware and configuration via the console port and TFTP client, you can also
upload the ZyWALL firmware and configuration files using FTP. To use this feature, your workstation
must have an FTP client.
When you telnet into the ZyWALL, you will see the following screens for uploading firmware and the
configuration file using FTP.
Firmware and Configuration File Maintenance
DESCRIPTION
This is the filename on the ZyWALL. The filename for the
firmware is "ras" and for the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
ZyWALL 10 Internet Security Gateway
10-9