Omron F150-2 Setup Manual page 9

About this Manual:
This manual describes the hardware for the F150 Vision Sensor and how to install the
components, and it includes the sections described below. This is one of three manuals
used to operate the F150. Refer to the following table for the contents of each manual.
Manual
1: Setup
Manual
2: Auto Menu
Operation
Manual
3: Expert
Menu
Operation
Manual
Please read the above manuals carefully and be sure you understand the information
provided before attempting to install or operate the F150.
Section 1 Before Installing describes the precautions that must be taken when instal-
ling and operating the F150 Vision Sensor.
Section 2 Product Introduction provides an overview of F150 application and
describes the wiring, Cameras, optical lenses, lighting modes, and light guides used in
the F150 System. It also describes how to mount the Vision Mate Controller to DIN Track
or to a flat surface.
Section 3 Terminal Blocks describes how to connect the terminal blocks.
Section 4 RS-232C Connection describes how to connect the RS-232C port.
Section 5 CompoBus/D Connections describes how to connect the
F150-C10E-2-DRT Vision Sensor as a CompoBus/D Slave and provides information
such as connector pin allocations, node number settings, and baud rate settings.
Section 6 Troubleshooting lists the errors that may occur, along with their probable
causes and remedies.
Section 7 Maintenance provides information on maintenance and inspection.
Section 8 Specifications provides the specifications of the F150 components.
WARNING
!
Contents
Provides information on system hardware and
installation. Be sure to read this manual first.
Describes operation of the F150 using the Auto
Menu. The Auto Menu enables the simplest
operation based on registered images of
acceptable and unacceptable products.
Describes operation of the F150 using the Expert
Menu. The Expert Menu enables application of all
F150 capabilities, including setting region images
and criteria.
Failure to read and understand the information provided in this
manual may result in personal injury or death, damage to the
product, or product failure. Please read each section in its
entirety and be sure you understand the information provided
in the section and related sections before attempting any of
the procedures or operations given.
Cat. No.
Z132
Z133
Z134
ix