Maintenance Parts And Replacement - Omron F150-2 Setup Manual

Maintenance Parts and Replacement

7-1 Maintenance Parts and Replacement
Maintenance parts of the F150 are shown in the following table.
Note
Replacing the Lens or Light
Note Follow these steps in the reverse order to mount the Lens and
Light.
Caution
!
Do not disassemble the Lens. Disassembly can damage the
Lens.
56
Part
20-mm Lens (20 mm × 20 mm)
50-mm Lens (50 mm × 50 mm)
Light
1. The Light will gradually lose illumination if used for long peri-
ods (approx. 20% loss after 1,500 hours of use). Replace
the Light after approx. 1,500 hours of use.
2. Replace the Light if it is partially damaged or not fully func-
tioning.
Camera base
Hold this section of the
lens when removing.
1
Disconnect the light cable from the light connector on the
back of the Camera.
2
Remove the light cable from the slot in the camera base.
Remove the two M3 × 6 screws securing the Light.
3
4
Remove the Light from the Camera.
5
Remove the Lens from the camera mount.
Model No.
F150-LE20
F150-LE50
F150-LT10
Hold this section when
removing the Cable.
Light connector Camera cable
connector
Section 7-1