Table 2-8. Quarter-Bridge Completion Resistors And Corresponding Channels - National Instruments SC-2043-SG User Manual

Installation and Configuration
Additionally, there are sockets for eight quarter-bridge completion resistors. When inserted, the
quarter-bridge completion resistors connect to the positive inputs of the instrumentation
amplifiers and the -EXn terminals. To configure a channel for quarter-bridge completion, set the
corresponding bridge completion jumper to the HB position and insert your quarter-bridge
completion resistor into the appropriate sockets. The parts locator diagram, Figure 2-1, shows
where these quarter-bridge completion resistor sockets are located. Table 2-8 lists the quarter-
bridge completion resistors and corresponding channels.

Table 2-8. Quarter-Bridge Completion Resistors and Corresponding Channels

SC-2043-SG User Manual
Channel Resistor
0 R52
1 R36
2 R20
3
4 R54
5 R37
6 R23
7
2-8
R6
R9
© National Instruments Corporation
Chapter 2