Table of Contents
Advertisement
P-661H/HW Series User's Guide
Figure 29 Wireless LAN Setup Wizard 2
The following table describes the labels in this screen.
Table 17 Wireless LAN Setup Wizard 2
LABEL
Network
Name(SSID)
Channel
Selection
Security
Back
Next
Exit
68
DESCRIPTION
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the ZyXEL Device, make sure all wireless stations use the
same SSID in order to access the network.
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.
Select Automatically assign a WPA key (Recommended) to have the ZyXEL Device
create a pre-shared key (WPA-PSK) automatically only if your wireless clients support
WPA and OTIST. This option is available only when you enable OTIST in the previous
wizard screen.
Select Manually assign a WPA-PSK key to configure a Pre-Shared Key (WPA-PSK).
Choose this option only if your wireless clients support WPA. See
page 69
for more information.
Select Manually assign a WEP key to configure a WEP Key. See
page 69
for more information.
Select Disable wireless security to have no wireless LAN security configured and
your network is accessible to any wireless networking device that is within range.
Note: If you enable OTIST in the previous wizard screen but select
Disable wireless security here, the ZyXEL Device still creates
a pre-shared key (WPA-PSK) automatically.
If you enable OTIST and select Manually assign a WEP key,
the ZyXEL Device will replace the WEP key with a WPA-PSK
Click Back to display the previous screen.
Click Next to proceed to the next screen.
Click Exit to close the wizard screen without saving.
Section 3.2.1 on
Section 3.2.2 on
Chapter 3 Wizards
Advertisement
Table of Contents
Troubleshooting
