Wireless Client; Figure 61 Example Wireless Client Otist Screen; Table 42 Otist - ZyXEL Communications P-661HW User Manual

P-661H/HW Series User's Guide
The following table describes the labels in this screen.

Table 42 OTIST

LABEL
Setup Key
Yes!
Start

6.5.1.2 Wireless Client

On your wireless client, start the ZyXEL utility and click the Adapter tab. Select the OTIST
check box, enter the same Setup Key as your AP's and click Save.

Figure 61 Example Wireless Client OTIST Screen

122
DESCRIPTION
Type an OTIST Setup Key of exactly eight ASCII characters in length.
The default OTIST setup key is "01234567".
Note: If you change the OTIST setup key here, you must also
make the same change on the wireless client(s).
If you want OTIST to automatically generate a WPA-PSK, you must:
Change your security to any security other than WPA-PSK in the Wireless
LAN > General screen.
Select the Yes! checkbox in the OTIST screen and click Start.
The wireless screen displays an auto generated WPA-PSK and is now in WPA-
PSK security mode.
The WPA-PSK security settings are assigned to the wireless client when you
start OTIST.
If you already have a WPA-PSK configured in the Wireless LAN > General
screen, and you run OTIST with Yes! selected, OTIST will use the existing
WPA-PSK.
Click Start to encrypt the wireless security data using the setup key and have
the ZyXEL Device set the wireless client to use the same wireless settings as
the ZyXEL Device. You must also activate and start OTIST on the wireless
client at the same time.
The process takes three minutes to complete.
Chapter 6 Wireless LAN