Snmp Traps; Configuring Snmp; Table 107 Snmpv1 Traps; Table 108 Snmpv2 Traps - ZyXEL Communications P-661HW User Manual

17.6.2 SNMP Traps

The ZyXEL Device will send traps to the SNMP manager when any one of the following
events occurs:

Table 107 SNMPv1 Traps

TRAP # TRAP NAME
0 coldStart (defined in RFC-1215)
1 warmStart (defined in RFC-1215)
6 whyReboot (defined in ZYXEL-
MIB)
6a For intentional reboot:
6b For fatal error:

Table 108 SNMPv2 Traps

OBJECT LABEL
SNMPv2 Traps
Cold Start
WarmStart
linkDown
linkUp
RFC 1493 Traps
newRoot
topology change

17.6.3 Configuring SNMP

To change your ZyXEL Device's SNMP settings, click Advanced > Remote MGMT >
SNMP. The screen appears as shown.
Chapter 17 Remote Management Configuration
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent with the reason of restart before
rebooting when the system is going to restart (warm
start).
A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
OBJECT ID DESCRIPTION
1.3.6.1.6.3.1.1.5.1 This trap is sent when the switch is turned on.
1.3.6.1.6.3.1.1.5.2 This trap is sent when the switch restarts.
1.3.6.1.6.3.1.1.5.3 This trap is sent when the Ethernet link is down.
1.3.6.1.6.3.1.1.5.4 This trap is sent when the Ethernet link is up.
1.3.6.1.2.1.17.0.1 This trap is sent when the STP topology changes.
1.3.6.1.2.1.17.0.2 This trap is sent when the STP root switch changes.
P-661H/HW Series User's Guide
257