Troubleshooting; Storage; Machine Washing And Cleaning; Disposal Of Packaging And The Machine At The End Of Its Service Life - Vari OP-115 Translation Of The Original Instructions

2.6.4

Troubleshooting

Problem
The rake belt does not rotate, the
engine runs at maximum speed quite
normally
The rake belt jerks
Another defect
Table 13: Troubleshooting
2.6.5

Storage

Prior to any long-term storage (e.g. at the season end) remove all the dirt and plant residues from the machine. Prevent unauthorized
persons from access to the machine. Protect the machine against climatic conditions but do not use impermeable protection to prevent
excessive corrosion it may cause.
We strongly recommend the following steps:
●
Preserve the connecting flange and unpainted machine parts
●
Remove all the dirt and plant residues from the machine.
●
Repair any paint damage.
●
Perform post-season lubrication of the machine, see Table 8 .
2.6.5.1

Machine washing and cleaning


When washing and cleaning the machine, proceed so as to observe valid provisions and laws regarding protection
of water courses and other water resources against pollution or contamination by chemical agents.

You may use a pressure washer for washing the tedder.
2.6.6

Disposal of Packaging and the Machine at the End of its Service Life

When you unpack the machine you are bound to dispose of the packaging material according to national laws and decrees concerning
waste disposal.
When disposing of the machine at the end of its service life, we recommend proceeding as follows:
●
Demount from your machine all the parts that may still be used.
●
Drain oil from the engine into a suitable closing container and dispose it in a waste collection centre
●
Dismount plastic parts and non-ferrous metal parts.
●
The remaining machine and its removed demounted parts are to be disposed of according to national laws and decrees
concerning waste disposal.
2.6.7

How to Order Spare Parts

These Operating Instruction do not include the list of spare parts.
For correct identification of your device, you have to know the type designation (Type), serial identification number (№) and order
number (C№) stated on the nameplate of the device, on the box or in the warranty card. Only with this information it is possible to search
correctly for the designation of the respective spare part with your dealer.
To search spare parts in the electronic catalogue of spare parts at http://katalognd.vari.cz, the first 10 characters of the identification
number (№) are sufficient. If you do not have Internet access, you can ask for the printed catalogue to be sent C.O.D.
14 The respective local authority will inform you of the disposal centre location.
Cause
The gearbox drive is not switched on
Broken drive belt
Fallen drive belt
Another defect
Centrifugal clutch slips - engine fault
Loosen drive belt
Loosen rake belt
Another defect
OP-115 OP-145 OP-115R ROP-115
Solution
Switch on the gearbox drive
Replace the belt with a new one
Mount the belt back.
Visit a service facility
Check the cleanliness of the clutch, check the integrity of the
clutch lining
Tighten the belt
Tighten the rake belt
Visit a service facility
Visit a service facility
.
14
21