Step Recording Of Bass Track - Zoom RhythmTrak RT-223 Operation Manual

position advances by one step.
When the end of the pattern is reached, the
recording loops back to the beginning and
continues, allowing you to add to the recording.
8.
To erase the sound of a specific pad,
use the [REPEAT/STEP] key to move
to its position. Then press the
corresponding pad while holding
down the [DELETE/ERASE] key.
When you move the position with the [REPEAT/
STEP] key, the pad for the sound input at the
current point lights up. When you delete the
sound by pressing the pad while holding down the
[DELETE/ERASE] key, the pad goes out.
Drum track
Snare
drum
Bass
drum
Snare
drum
Bass
drum
NOTE
During step input, it is not possible to
erase the entire track in one go.
9.
When step input of the drum track is
finished, press the STOP [
ZOOM RT-223
Pad
P
] key.
Entering Patterns Using Step Input
O
The REC [ ] key goes out, and step input
terminates.
Step recording of bass
track
Now let's add a bass track to the drum track
recorded as described in the previous section.
Because pitch and duration must be specified for
the bass track, the procedure is slightly different
from step recording of the drum track.
1.
In pattern mode, press the [BASS]
key.
The bass track is selected. The bass program
selection method is the same as for real-time
recording (→ p. 25).
2.
Press the [FUNCTION] key and then
pad 5 (QUANTIZE).
QNTIZE
Quantize value
You can now set the quantize value.
16
29