Routine And Special Maintenance - Promac SY-315 Manual

9.7 Changing the saw blade
Release the frame (B) of the movable chip protection (A)
so it moves freely.
- Place a piece of wood in the clamp and lower the saw
blade on top of it.
- Release the screw (C) with the blade key.
NOTE:
Left-hand thread - turn clockwise!
- Remove the blade flange (E) and saw blade (D).
Clean all parts, fit a new saw blade and blade flange, and
tighten the blade screw.
9.8 Cleaning and accessing the coolant system
- Pull out the drain hose from the filter (A).
- Pull out the coolant tank from the coolant platform in the
stand.
- Remove the filter (A) from the tank
SY-315 / SY-315L
- Pour out the coolant, wash out the dirt and debris.
Replace the filter (A), replace the coolant tank in reverse
order of removal.
Fill with coolant solution of 1:10 ratio of coolant to water.

10. Routine and special maintenance

THE MAINTENANCE SCHEDULE HAS BEEN DIVIDED
INTO DAILY, WEEKLY, MONTHLY, AND SIX-MONTHLY
INTERVALS. NEGLECTING THE MACHINE
MAINTENANCE WILL RESULT IN PREMATURE WEAR
AND POOR PERFORMANCE.
10.1 Daily maintenance
Make a general cleaning by removing dust and shavings
from the machine.
Top off the coolant.
Inspect the disk/saw blade for wear.
Raise the head into a high position to reduce stress on the
return spring.
Check that the shields and emergency stops are in good
working order.
10.2 Weekly maintenance
Thoroughly clean the machine including the coolant tank.
Clean and grease the vice screw and sliding surfaces.
Clean the housing for disk/saw blade.
Sharpen the saw teeth.
10.3 Monthly maintenance
Check that all screws on the motor, the pump, the vice jaws,
and the guard are tight and secure.
13