Adjusting Your Machine - Promac SY-315 Manual

A Push lever with trigger switch
B Mobile blade guard
C Saw blade
D Quick action stick lever
E Adjustment handle quick action sledge
F Adjustment level mitre setting of sawhead
G Machine foot with coolant
H Splash guard
I Longitudinal stop
J Control unit with
1 Stop button
2 Operating button
3 Emergency/off switch
4 Pump on/off switch
5 Rotations selector
K Reducer with 2-speed engine

7 Adjusting your machine

7.1 Anchoring the machine
Position the machine on a firm and level concrete floor.
Maintain a minimum distance of 800mm from the wall to
rear of the machine. Anchor the machine to the ground,
as shown in the diagram, using screws and expansion
plugs or sunken tie rods that connect through holes in the
base of the stand. Ensuring that it is sitting level (see
picture).
7.2 Unpacking
Remove packaging. Remove all accessories (A) and the
coolant system (B) from the pallet.
SY-315 / SY-315L
Lift the stand (C) and place into the intended working location
(D).
7.3 Mount the machine on the base or workplace.
This will require a crane or stacker truck with lifting ropes.
Carefully place the lifting rope (E) to the hooks (F, Fig 3b)
and carefully position the machine on the base or workplace.
7